The Varistor Production Equipment Is An Integrated Machine For Testing, Marking, Pin Cutting And Pin Pulling

1. Name and Purpose
1.1 Name: Varistor Testing, Marking, Cutting and Unplugging Integrated Machine LJYT-B

1.2 Application: It is used in the post-production process of varistors

2. Basic functional requirements: The material should be placed on a short paper tape of 316-320mm (positioned by the product head), with pin spacing of 5mm/7.5mm/10mm

3 Technical Index Requirements:
Manual feeding to the material trough → automatic feeding → tail ring cutting →- Test Station 1 (sliding test) (automatic removal of defective products) → Single-sided laser marking (50W fiber vision marking machine) → Pin pulling, counting and packaging → Insulation pin alignment → Short pin cutting, counting and packaging (circular knife cutting) → Waste wire pulling mechanism → 10-position turntable material collection

4. Supply scope: 1 integrated machine for varistor testing, marking, appearance, cutting and unplugging

5 Technical Data
5-1. Voltage: Single-phase 220V. Power: 3KW. Use an air pressure of 5 to 6 kilograms.
5-2. Efficiency: Approximately 15-18KPCS/H for single-sided testing
5-3. The machine is made of aluminum profiles, and the panel is painted sky blue.
5-4. It adopts a sliding measurement design, and the test time is adjusted by the instrument. During work, the test product is positioned at the center of the head by a fiber optic amplifier, and it can be moved up and down by reversing
Lift the control mode.
5-5. Defective products adopt a pull-out design and are made in a mechanical claw mode combining two sets of cylinders.
5-6. The feeding/discharging process adopts vacuum suction for feeding and push plate output for material collection. The automatic feeding is carried out by a motor crankshaft in a circular operation mode, with controllable photoelectric control
Inductive mode.
5-7. The automatic cutting and pull-out material collection adopt a rotary operation and also feature a controllable photoelectric sensing mode (counting packaging).
Tail cutting ring: It adopts an upper and lower circular knife cross design to cut off the tail of the lead wire. The knife seat can be adjusted forward and backward through fine-tuning.
5-8. Single-sided fiber optic vision marking machine, suitable for a passage width of 14.5mm (Y-direction paper tape width)
The spacing of the positioning paper tape is 320±1.5mm
5-10. Laser power: 50w; Laser wavelength: Special customization;
5-110. Scanning speed: ≥300 pieces per minute; Marking range: 400mm × 450mm;
5-12. Marking: Static marking, no deformation, no missing characters, no double images, no deviation.
5-13. Alarm Function: This machine is equipped with a built-in fault alarm function and fault early warning function
5-14. Power input: 220V/50HZ. It can operate continuously for 24 hours without interruption.
5-15. Test instrument: Huigao HG2515